Use of Concealing Alkaline Ionizer
Purified water
Alkaline ion water
W
eak acidic water
The water quality indicator light is in red.
The water quality indicator light is in green.
Continuous warning sounds will be made.
( To avoid accidental drinking due to
carelessness)
Convenient using method
Press to
choose your preferred water quality.
Press .
(A warning sound of “Plˮ will be made.)
Press .
(A warning sound “Pl
ˮ
will be made.)
Mild
Rice cooking
Strong
Tea, dish cooking, hot pot, soup,
etc.
Baby milk or medicine
When washing your face with weak
acidic water close to your skin
Weak Acidic
Purified
Preparation
❶
Choose water quality.
Store the previously used water quality.
To change water quality, see below.
Outlet water
❶
Press
Water
Stop/Flow
.
❷
Before using, confirm the water
signal indicator.
After the water signal indicator is in blue and
flashing, use after there are three warning
sounds “PI, PI, PI” and the light is on.
If the water is splashing, please tighten the
water stop valve a little bit. (For the water
pressure is relatively high.) (P.EN17)
When the flow is lower than 1.0 L per
minute, the water signal indicator will flash.
When the flow is reduced to less than 0.8
L per minute and lasting for more than 1
minute, the water will not flow out. (For the
water pressure is relatively low.) (P.EN17)
The Alkaline Ionizer cannot operate stably
unless the flow is more than 1.2 L per minute.
1
2
Every time you press
Alkaline
Adjusting pH(3sec.)
, a warning sound of
“Pl
ˮ
will be made, and the pH level will change in
the order of “weak
ˮ →
“mild
ˮ →
“strong
ˮ.
The pH level will increase by about 0.5 in
the order of “weak
ˮ
, “mild
ˮ
, “strong
ˮ.
Applications of each strength are shown on
the right.
The water quality indicator light is in green.
→
Low
High
Adjusting pH(3sec.)
Alkaline
“weakˮ “mildˮ “strongˮ
EN16
01_TK-AB50-ZEX_ZMA_EN.indd 15
2018/09/28 14:49:25
