Replacing the Cartridge
(continued)
Replacing method
Do not unplug the power plug when replacing the cartridge.
(If the power plug is unplugged, the service life of the cartridge cannot be reset.)
Do not replace the cartridge with the condition of main unit flat.
Before replacing the cartridge, please close the faucet. After removing the cartridge, water run through
should be stopped. (Or water will spill.)
Remove the cover.
Remove the cartridge.
Press down the cartridge from the top, pull it forward as
shown in the figure, then the cartridge can be taken out.
Take care since water will drip from the cartridge.
Water may also emerge from the bottom of the make
unit (this does not indicate that there is a leak).
Please take out the cartridge with the tray.
Remove the tray from the
old
cartridge.
Please remove it in the kitchen sink.
(Because the water inside the cartridge will flow out.)
Do not
discard
the tray.
Install the tray on the new
cartridge.
1
2
3
4
Push slightly
Cover
❶
❷
❸
Old
cartridge
Pull toward you
Push down on the top
Pull up and out
Tray
The tray is below the
cartridge.
Install the tray.
EN20
01_TK-AB50-ZEX_ZMA_EN.indd 19
2018/09/25 16:50:14