Purified
Reset
Adjusting pH
Filter Replacement
Low
High
Water
Stop/Flow
Alkaline
Weak Acidic
Adjusting pH(3sec.)
(3 sec.)
Install the new cartridge.
Please confirm that the tray has been installed.
Please be sure that the upper and lower directions are right.
After putting the cartridge in place, push it up.
Press
Reset
(3 sec.)
(for about 3 seconds).
Please confirm that the
filter
replacement light is off.
Choose
Purified
and press
Water
Stop/Flow
run purified water through
the main unit
(for about 5 minutes).
After water run through, the water signal indicator will be in
blue and flashing for 20 seconds ~ 30 seconds.
While water is running through the unit, check that water is
not leaking from the area where the cartridge was installed.
Steps to exhaust the air inside the cartridge.
If the air is not exhausted, water can still easily dip from the
main spout or the drain outlet even if the water flow is stopped.
Press
Water
Stop/Flow
to stop
purified water
put
the cover
back on.
5
6
7
8
6: press
Alkaline
Adjusting pH(3sec.)
until the warning sound “PI-” is made (about 3 seconds). [To display the correct replacing time]
When alkaline ion water is poured into a glass after the cartridge has been replaced, it may contain white
bubbles: this is normal and does not indicate any trouble. (P.EN23)
Important
Dispose of the used cartridge in accordance with the applicable ordinances in the area concerned.
(The material of the cartridge cover is ABS. Refer to “Specifications” for the type of the filter materials (P.EN30).)
If the outflow has not been recovered after replacing the cartridge, it may be caused by the blocking of the gasket
attached with strainer of the water stop valve. Please contact a dealer or subordinate service station of Panasonic.
If the cartridge is replaced before the
filter
replacement light (red) is flashing or on,
please follow up step
Note
❶
❷
❸
New cartridge
Tray
Pull upward
Filter
R
eplacement
L
ight
Confirm the
light
off.
❶
❷
Engage the
tabs here.
Press until there
is warning sound.
Engl
is
h
Maintenance and replacement
EN21
01_TK-AB50-ZEX_ZMA_EN.indd 20
2018/09/25 16:50:27