8
First-time Operation
4
After reading the agreement, select [I accept the agreement] or [I don't accept
the agreement], then press [Next].
Setup Windows
5
Turn your computer on
4
Slide the power switch toward the rear of the computer and hold it for approximately
one second until the power indicator turns on before releasing it.
3
Enter your name and your company’s name, then press [Next].
(It is possible to omit the company name item.)
The License Agreement will be displayed.
Select settings for your region, then press [Next].
Select your keyboard layout, then press [Next].
(for U.S.A.: United States 101)
2
1
Moving the cursor (
) or clicking buttons can be performed with the
trackball (
page 12).
NOTE
Power Switch
Read the LIMITED USE LICENSE AGREEMENT
(
page 23)
3
To open the display, slide the latch located at the front and lift open the display. Before
removing the seal covering the power switch, please read the LIMITED USE LICENSE
AGREEMENT. Removal of this seal indicates agreement to the terms specified. After
you have agreed to the terms, you may turn your computer on.
CAUTION
Do not slide the power switch and hold it for more than four seconds.
Do not slide the power switch repeatedly.
Once the computer is powered off, you must wait at least ten seconds before
powering it on again.
2
1
Power Indicator
Connect your computer to a power outlet
CAUTION
Handling the AC adapter
Do not twist or pull the AC power cord forcefully. Doing so may damage the
connections.
Use only the specified AC adapter with your computer. Using an AC adapter
other than the one supplied might damage the battery and/or the computer.
When the DC plug is not connected to the computer, disconnect the AC cord
from your AC wall outlet well.
Problems such as sudden voltage drops/surges may arise during periods of thun-
der and lightning. Since this could adversely affect your computer, an
uninterruptible power source (UPS) is highly recommended unless the battery
pack is installed.
Be sure the AC adapter is connected until completing Step
8
on page 10.
2
1
3
6
NOTE
The power saving function is factory set, so if there is no input from a key, the
trackball, or the external mouse for a certain interval of time, the power to the
LCD is cut (ECO mode).
The LCD will resume operation when the trackball is used or a key is pressed.
The computer may enter the ECO mode while Windows is setting up or even
when an application software is being installed. In this case, because it is con-
ceivable that a selection dialog box will be shown, for resuming from the ECO
mode, do not press
Enter
which may trigger a selection, but instead, press a
key unrelated to the direct triggering of a selection, like
.
Shift
Summary of Contents for Touchbook CF-45
Page 30: ...MEMO ...
Page 31: ......
