6
Getting Started
Read Me First
These symbols on the products, packaging, and/or accompanying documents mean that used electrical and
electronic products and batteries should not be mixed with general household waste.
For proper treatment, recovery and recycling of old products and used batteries, please take them to ap-
plicable collection points, in accordance with your national legislation and the Directives 2002/ 96/EC and
2006/66/EC.
By disposing of these products and batteries correctly, you will help to save valuable resources and prevent
any potential negative effects on human health and the environment which could otherwise arise from inap-
propriate waste handling.
For more information about collection and recycling of old products and batteries, please contact your local
municipality, your waste disposal service or the point of sale where you purchased the items.
Penalties may be applicable for incorrect disposal of this waste, in accordance with national legislation.
For business users in the European Union
If you wish to discard electrical and electronic equipment, please contact your dealer or supplier for further
information.
Information on Disposal in other Countries outside the European Union
These symbols are only valid in the European Union. If you wish to discard this product, please contact your
local authorities or dealer and ask for the correct method of disposal.
Note for the battery symbol (bottom two symbol examples)
This symbol might be used in combination with a chemical symbol. In this case it complies with the require-
ment set by the Directive for the chemical involved.
53-E
Information for Users on Collection and Disposal of Old Equipment and
used Batteries
Camera Light
<For model with camera>
CAUTION
Camera Light
- This equipment uses LED (Light Emitting Diode) technology that complies with IEC60825-1:1993+A1:1997+A2:2001
- CLASS 1 LED PRODUCT
- The light from the LED is strong and can injure human eyes. Do not look directly at the LEDs with naked eyes.
- Caution-Use of controls or adjustments or performance of procedures other than those speci
fi
ed herein may result in
hazardous radiation exposure.
Speci
fi
cation
- Max Power
0.873 mW
When using Port Replicator or Car Mounter on which an external antenna can
be installed:
External antenna for wireless LAN must be professionally installed.
The gain of external antenna for wireless LAN must not exceed 5dBi.
The user must maintain minimum of 20 cm spacing between the external antenna and all people (excluding ex-
tremities of hands, wrist and feet) during wireless modes of operation.
41-E-1-1
CF-19CTQZZBM.indb 6
CF-19CTQZZBM.indb 6
6/15/2009 2:10:22 PM
6/15/2009 2:10:22 PM
