17
Standby Mode
or
Hibernation Mode
Shutting Down Using the Standby or Hibernation Function
The computer should be set for either the standby or hibernation function (
page 16
).
Rotate the power switch; at the “beep*
1
” sound, release your finger.
(After releasing your finger from the
power switch, do not touch the power
switch until the power indicator goes off
or blinks.)
Standby/Hibernation Functions
With the method below, you can shut down the computer by using the standby
function.
• Fn + F7 (
page 3
)
•
Windows 98
Windows 2000
In [Start] - [Shut Down], select [Stand by].
•
Windows NT
In [Control Panel] - [APM 2.0 for NT] - [Power Control], select [Click Here to
Suspend]. (
page 28
)
With the method below, you can shut down the computer by using the hiber-
nation function.
• Fn + F10 (
page 3
)
•
Windows 2000
In [Start] - [Shut Down], select [Hibernate].
CAUTION
At the “beep*
1
” sound, release your finger from the power switch. If you continue
to rotate the power switch and hold it for more than four seconds, the computer
will emit a second “beep*
1
” then power off. Data not previously saved will be
lost.
Windows 98 Windows 2000
Even when [When I press the power button on my computer] is set to [Shut-
down]*
2
with [Control Panel] - [Power Management]*
3
, if you rotate the power
switch for more than four seconds and do not release it, a second “beep*
1
” will
sound and the computer will power off, although the computer will not com-
pletely shut down.
NOTE
*
1
When the speaker function is disabled, e.g., by setting [Disable] for [Speaker] with the
Setup Utility (
page 53
) or by the key combination , there will be no beep
sound.
*
2
Windows 2000
: [Power Off]
*
3
Windows 2000
: [Power Options]
Fn + F4
