66
LAN
Enabling the Power On by LAN function
The computer automatically turns from off to on when the computer is accessed from the network server via the internal LAN port.
1
Select [Allow] in [Power On by LAN] in the [Advanced] menu of the Setup Utility
(
).
2
In [Caution], press
Enter
.
3
Press
F10
, and then select [Yes] and press
Enter
.
4
Log on to Windows as an administrator.
5
Click (Start) - [Computer] - [System properties] - [Device Manager].
Click [start] - [Control Panel] - [Performance and Maintenance] - [System] - [Hardware] -
[Device Manager].
6
Double-click [Network adapters] - [Intel(R) 82577LM Gigabit Network Connection], and
then click [Advanced].
7
Click [Enable PME] in [Property] and select [Enabled] in [Value], and then click [OK].
NOTE
z
The computer may accidentally turn on if the linkage status is changed. To prevent the accidental startup, make the
setting by the following steps.
A
Click
(Start) - [Computer] - [System properties] - [Device Manager].
z
A standard user needs to enter an administrator password.
Click [start] - [Control Panel] - [Performance and Maintenance] - [System] - [Hardware] - [Device Manager] -
[Network adapters].
B
Double-click [Network adapters] - [Intel(R) 82577LM Gigabit Network Connection], and click [Advanced].
C
Click [Wake on Magic Packet] in [Property] and select [Enabled] in [Value], and then click [OK].
Click [Wake on Settings] in [Property] and select [Wake on Magic Packet] in [Value], and click [OK].
z
If you forcibly shut down Windows, the Power On by LAN function will not work.
