33
Getting Started
Usef
ul Inform
ation
Troubleshooting
Appendix
*13
Only for model with wireless LAN.
*14
Only for model with Bluetooth.
*15
Only for model with wireless WAN.
*16
Only for model with 2nd LAN.
*17
Only for model with modem.
*18
Only for model with TPM.
For information on TPM, refer to the Installation Manual of
“Trusted Platform Module (TPM)” by the following procedure.
Click
(Start) and input “c:\util\drivers\tpm\README.pdf”
in [Search programs and files] and press
Enter
.
Click [start] - [Run] and input “c:\util\drivers\tpm\README.pdf”
and click [OK].
*19
Only for model with ExpressCard slot.
*20
Only for model without ExpressCard slot.
*21
This slot is compatible with High-Speed Mode. Operation has
been tested and confirmed using Panasonic SD/SDHC/
SDXC Memory Cards with a capacity of up to 64
GB
. Opera-
tion on other SD equipment is not guaranteed.
*22
Only for model with Smart Card slot.
*23
Does not guarantee operation of all USB-compatible periph-
erals.
*24
Only for model without 2nd LAN.
*25
Does not guarantee operation of all HDMI-compatible periph-
erals.
*26
Only for model with IEEE 1394a interface.
*27
Only for model with Fingerprint reader.
*28
Only for model with Web Camera.
*29
Measured with LCD brightness : 60
cd
/
m
2
Varies depending on the usage conditions, or when an
optional device is attached.
*30
Varies depending on the usage conditions, CPU speed, etc.
*31
Approx. 0.5
W
when the battery pack is fully charged (or not
being charged) and the computer is off.
<When using with 115
V
AC>
Even when the AC adaptor is not connected to the computer,
power is consumed (Max. 0.2
W
) simply by having the AC
adaptor plugged into an AC outlet.
<When using with 240 V AC>
Even when the AC adaptor is not connected to the computer,
power is consumed (Max. 0.3 W) simply by having the AC
adaptor plugged into an AC outlet.
*32
Rated power consumption.
23-E-1
*33
Do not expose the skin to this product when using the prod-
uct in a hot or cold environment. (
Î
page 9)
When using in hot or cold environment, some peripherals
may fail to work properly. Check the operation environment
of the peripherals.
Using this product continuously in a hot environment will
shorten the product life. Avoid use in these types of environ-
ments.
When using in low temperature environment, startup may
become slow or battery operation time may become short.
The computer consumes power when the hard disk is warm-
ing up during startup. Therefore, if you are using battery
power and the remaining power is low, the computer may not
start up.
*34
When reinstalling Windows using the data of the recovery
area on the hard disk, you can select the OS to be installed
(either Windows 7 (32-bit) or Windows 7 (64-bit)). An OS that
has been installed at the time of purchase or an OS that has
been installed using the hard disk recovery function or the
recovery disc can be supported.
*35
The downgrade service is available only for corporate users
who fulfill certain conditions.
*36
Must be installed before use.
*37
Perform on the recovery partition. (If this software can not be
performed on the recovery partition, perform from the recov-
ery disc)
*38
These are speeds specified in IEEE802.11a+b+g+n stan-
dards. Actual speeds may differ.
*39
Available when set to “AES”.
*40
Only available when HT40 enabled by the computer and
access point which associated supports HT40.
CPE02360ZB_CF-53mk1_7XP_E.book 33 ページ ２０１１年５月１９日 木曜日 午後１時４５分
