31
T
roubleshooting
Some applications may not
work properly
Fast User Switching Function
When switching to a different user with the Fast User Switching function, the following
problems may occur.
• Some applications may not work properly.
• Key combination with
Fn
may not work.
• It may not be possible to set the settings of the display.
• The wireless LAN cannot be used.
SD Memory Card
Cannot log on with the SD
memory card
Windows logon user name and password are not set in the SD memory card correctly.
Enter the Windows user name and password without using the SD memory card.
After logging on, set the same user name and the password on the SD memory card and
Windows, using one of the following operations.
• Change the setting of the SD memory card side by [SD Card Setup].
• Change the setting of the Windows side by [Control Panel].
Battery Indicator
The red indicator lights
The red indicator blinks
The orange indicator blinks
The battery level is very low (the charge is approx. 9% or less).
Connect the AC adaptor. You can use the computer when the indicator light is orange. If
you do not have an AC adaptor, save your data and power off your computer. After replac-
ing the battery pack with a fully charged one, turn your computer on.
Quickly save your data and power off your computer. Remove the battery pack and dis-
connect the AC adaptor, then connect them again.
If the problem persists, contact your technical support office (
page 44). The battery
pack or charging circuit may be defective.
Battery cannot be recharged temporarily because the internal temperature of the battery
pack is outside of the acceptable temperature range for recharging. Once the allowable
range requirement is satisfied, charging begins automatically. Your computer can be used
normally in this state.
Is Acrobat Reader installed?
If Acrobat Reader is not installed, run [c:\util\reader\acroreader51_enu_full.exe] in [start]
- [Run] to reinstall the program. When installing the program, do not change the installa-
tion destination folder. If the destination folder is changed, the Reference Manual cannot
be opened from [start] menu.
Reference Manual
The Reference Manual is
not displayed
You do not know the avail-
able RAM module
Cannot tell whether the
RAM module has been cor-
rectly installed
The RAM module has not
been recognized
RAM Module
page 21
You can check whether the RAM module is recognized using [Information] menu in the
Setup Utility. If the RAM module is not recognized, turn the computer off and reinsert the
RAM module.
Make sure the RAM module has been properly inserted.
Use the RAM module that supports the recommended specifications (
page 21).
Summary of Contents for Toughbook CF-T2DWATZKM
Page 46: ...46 Memo ...
Page 47: ...47 ...