6
INSTALLATION AND SET---UP
Switch ON your VCR. *
1
Switch ON your Satellite Receiver.*
2
Plug the TV into a mains socket and switch ON.
If the TV has not been programmed for you
then
Auto setup
will begin. TV stations will
be located and stored ready for use. *
3
Switch the VCR Test Signal ‘off’. *
4
Programmes will appear immediately if your
dealer has programmed the TV for you.
The first available channel will be displayed.
Programme change
Volume adjust
2
3
4
ATP
02
41
CH21
1
CH41
TELETEXT
99:21
*1.
We recommend that you switch ON the VCR’s test signal --- refer to your VCR instruction book.
*2.
We recommend that your Satellite Receiver is set to either SKY ONE or SKY NEWS to ensure reliable tuning.
*3.
If the order in which the stations are stored is not to your preference it can be rearranged. Refer to the Tuning menu Swap feature
--- see page 9 for details.
*4.
IT IS IMPORTANT
that you only use TV programme position ‘0’ to view your VCR. If your VCR picture does not appear on
programme position ‘0’ (the VCR position), refer to page 12 for guidance.
