15
TUNING MENU
AUTO TUNE
Before AUTO TUNE, set the “CH SELECT” and “SYS SELECT”.
Follow the step on the previous page to display the TUNING MENU screen.
1. If a clear picture with correct colours cannot be obtained when a Broadcast or AV signal is received, refer to the “Colour System
Selection” operation on page 14.
2. After the Automatic tune is finished, press the Programme Number “Up” Button to confirm the tuning condition for each Programme
Number. If some Programme Numbers are unused, it is possible to skip such Programme Numbers. Please refer to the Programme skip
function on page 14.
Helpful Hint
1
Press to select AUTO TUNE.
Press to access AUTO TUNE.
Notes:
• If you proceed with the next step all tuning data will be erased (all stations
and their programme positions stored in your TV's memory will be wiped out
so that the new settings can be stored).
• If you exit the procedure after this point and before AUTO TUNE is
complete, no station information will be stored. Restart and complete
the AUTO TUNE procedure so that the TV is re-tuned.
2
Press to start AUTO TUNE.
Once this operation is completed the TV will display the program now
stored on programme position 1.
CH 29
29
AUTO SETUP IN PROGRESS
SEARCHING :
SETUP : RETURN TO TUNING MENU
TV/AV : TO EXIT
STORED CH29
SYS SELECT
MANUAL TUNE
SOUND SYS
COLOUR SYS
5.5MHz
SKIP
OFF
AUTO
ASIA/M. EAST
CH SELECT
DIRECT
ACCESS
FINE TUNE
TUNING MENU
AUTO TUNE
1
Press
(Side panel) until Tuning mode is reached.
2
Press
or
to access Tuning mode.
3
Press
(Side panel) to access Auto tune.
4
Press
or
to start search.
Press
at any time to exit the Tuning menu.
AUTO TUNE (via side panel)
It is also possible to use the control panel buttons on the side of the TV to tune individual programme positions
Press at any time to go back to watching TV (please read
the Note in the above procedure).
TV/AV
