- 88 -
Note
●
TV Guide
may also be used to set timer event.
Watching > TV Guide > Timer Programming
●
Timer Programming
can store up to 15 events.
●
Timer Programming
only works reliably if correct time information is
received via the signal from the broadcaster or service provider.
●
For recording using
Timer Programming
, the TV must be either on or in
Standby. For reminders to be displayed, the TV must be on.
●
No other channels can be selected while the recording of
Timer
Programming
is in progress.
●
Recording an encrypted (copy-protected) programme may not be possible.
●
Depending on the network condition, recording function may not work
properly in DVB-via-IP.
●
2 minutes before the start time, a reminder message appears if you are
watching TV.
– To remove the message and start the programming, press
OK
.
– To cancel the programming, press
EXIT
.
●
LED will turn to orange in Standby mode if
Timer Programming
is set.
●
Reminder messages will remain displayed until one of the following
occurs:
– You press
OK
to view the programme or
EXIT
to cancel the reminder.
– The timer event that the reminder is set for ends.
●
“!” identifies that two or more timer events are overlapped.
USB HDD Rec.
is given priority over
Reminder
. As for the overlapped recording events,
the first event starts and finishes as programmed. The next event can then
start.
●
The recording of
Timer Programming
will automatically change the
channel to the programmed channel a few seconds before the start time.
●
The recording of
Timer Programming
will be performed even if the TV is
in
REW LIVE TV
recording. In this case,
REW LIVE TV
recording will be
cancelled.
Recording > Recording current programme > REW LIVE TV
●
For more information of the USB HDD
