- 96 -
New Channel Message
Selects whether to give a notification message when a new DVB channel is
found or not.
●
When a notification message appears, you can perform
Update Channel
List
pressing
OK
.
●
Not valid in DVB-via-IP
Signal Condition
Selects a channel and checks the signal condition with indicators.
●
A good Signal Strength is not an indication of suitable signal for DVB reception.
●
Vertical lines show the maximum signal value of the selected channel.
●
To change the channel
●
For DVB
Other settings
Favourite Network
Selects your favourite network for each broadcaster (only available in some
countries).
●
For DVB-C, DVB-T
Service Replacement
(
On
/
Off
)
Set to
On
to display a message to switch to the available service (only
available in some countries).
●
For DVB-C
Attenuator
(
On
/
Off
)
Sets the antenna system to use plural LNBs for receiving several satellites.
●
If the DVB-C signal is too strong, the interference may occur. In this case,
set to
On
to weaken the signal automatically.
Add TV Signal
Adds the TV mode.
●
This function is available if you skip any modes to tune in
Auto Setup
for
first using the TV.
Summary of Contents for TX-39ASW654
Page 260: ...Ver 2 02 ...