13
Fixed Volume Enable
Enables (Fixed Volume Enable = On) or prohibits (Fixed Volume Enable = Off) the use of fixed volume value which
is set by menu item “Fixed Volume Value”. If Fixed Volume Enable is ON, volume cannot be set to a value other
than the Fixed Volume Value.
Fixed Volume Value
Sets the fixed value the volume can have. If Fixed Volume Limit is ON, volume is set with the value here.
Headphone Direct Volume
Enables the remote controller /- buttons to change the headphone volume directly. When this features is
active, /- buttons changes only headphone value, and to change the TV main sound it can be control from
sound OSD dialog only.
OSD Disable
Disables either only Setup menu or all menus, both in analog and digital (IDTV) mode.
All Menus : All menus (MAIN, SOUND, PICTURE, SETTINGS, INSTALLATION) are invisible.
OSD Disable = Disable Setup Menus : Only SETUP menus are invisible.
Invisible Setup Menus are:
Main menu: Installation, Channel list
Settings menu: Language, parental, Sources, Other settings
Teletext
Enables (Teletext = On) or prohibits (Teletext = Off) the use of teletext (or MHEG if available)
WakeUp Time Channel
To choose the TV set wake up channel.
Wakeup Time Volume
To modify the volume of TV wake up volume ( It cant be set higher volume than volume limit).
Copy To USB
There are two steps and both are independent of each other.
Copy the updated welcome image to USB as “hotel_wel.png”
Copy NVRAM data (service list, preferences, etc.) to USB device. On MB9x all nvram data is stored in 8x32KB
Flash files named as Flash0.bin, Flash1.bin ... Flash7.bin. When Copy to USB is called, those files are copied from
TV to USB. Then they can be used for various purposes testing on another TV or testing/debugging on observatory
etc. Note that USB should be plugged before this operation.
Copy From USB
There are two steps and both are independent of each other.
If there is file named “hotel_wel.png” in directory “welcome_image”. It is copied to tv to use as welcome image.
Copy from USB device data to NVRAM. Just the reverse operation done by copy to USB call. Previously copied
nvram files (Flashx.bin) are copied into TV. If there is no flash file or some of them are available on USB, the
available ones are copied. If no USB is connected, nothing happens.
Note :
For Clone function USB stick (Copy to USB
– Copy from USB) must be formatted to FAT32. If USB is not
formatted to FAT32 the other TVs will not accept cloned data and performance issues will result
USB Option
If ON is selected TV will go on normal operation. If It is OFF USB device will not receive on none of the USB ports
Fixed Pic. Mode
If OFF is selected TV will go on normal operation. If It is ON Main menu/Picture quick menu/mode and quick
menu/picture zoom will be inaccessible.
Digital Tuner
If ON is selected TV will go on normal operation. If It
is OFF TV will display “no signal” message when tuned to
digital channels existing in active channel list, and digital channels will not be detected in auto or manual searches.
Summary of Contents for TX-40CXW404
Page 22: ...21 ...
