Note
●
TV Guide
may also be used to set timer event.
Watching > TV Guide > Timer Programming
●
Timer Programming
can store up to 15 events.
●
Timer Programming
only works reliably if correct time information is
received via the signal from the broadcaster or service provider.
●
For recording using
Timer Programming
, the TV must be either on or in
Standby.
●
No other channels can be selected while recording of
Timer Programming
is in progress.
●
Recording an encrypted (copy-protected) programme may not be possible.
●
Depending on the network condition, recording function may not work
properly in DVB-via-IP.
●
When the start time comes, the channel will be switched automatically and
the video and audio signals will be output. 2 minutes before the start time,
a reminder message appears if you are watching TV.
– To remove the message and start the programming, press
OK
.
– To cancel the programming, press
EXIT
.
●
LED turns to orange in Standby mode when
Timer Programming
is set.
●
“!” identifies that two or more timer events are overlapped. As for the
overlapped recording events, the first event starts and finishes as
programmed. The next event can then start.
●
The recording of
Timer Programming
automatically changes the channel to
the programmed channel a few seconds before the start time.
●
For details of the USB HDD
Recording > Technical information
- 124 -
Summary of Contents for TX-40DX600E
