Manual Tuning
●
Normally use
Auto Setup
or
Update Channel List
to retune DVB channels.
●
If tuning has not been done completely or for adjusting the direction of the
aerial, use this function. (DVB)
●
All DVB channels found are added to
Channel List Editor
.
■
DVB (UK only)
1. Select
Frequency
.
2. Press
OK
to search.
●
All channels found are added to
Channel List
.
■
DVB (Ireland only)
1. Select a channel and adjust frequency for each channel.
●
Set where the level of
Signal Quality
becomes the maximum.
2. Press
OK
to search.
■
Analogue
Set Analogue channel manually after
Auto Setup
.
1. Select the channel position with
Numeric buttons
.
2. Select the channel with
Channel Up / Down
.
3. Set
Manual Tuning
.
4. Select
Store
and press
OK
to set.
●
Use
Fine Tuning
to make small adjustments to the tuning of an individual
programme (affected by weather conditions, etc.).
– Ireland only
●
If a VCR is connected only with the RF cable, select channel position
0
.
- 113 -
Summary of Contents for TX-40EX700B
