5
English
ANT INPUT
ANT OUTPUT
Antenna connection
For proper reception of VHF / UHF channels, an external antenna is required. For best reception, an outdoor
antenna is recommended.
VHF Aerial
UHF Aerial
OR
75
Ω
Coaxial cable
VCR
Mixer
Notes:
• Do not put the Coaxial cable close to the Power cable to avoid noise.
• Do not place the Coaxial cable under the unit.
• Additional equipment, cables and adapter plugs shown are not supplied with this set.
• To obtain optimum quality picture and sound, an Aerial, the correct cable (75
Ω
coaxial) and the correct
terminating plug are required.
• If a communal Aerial system is used, you may require the correct connection cable and plug between the wall
Aerial socket and your set.
• Your local Television Service Centre or Dealer may be able to assist you in obtaining the correct Aerial system for
your particular area and the accessories required.
• Any matters regarding Aerial installation, upgrading of existing systems or accessories required, and the costs
incurred, are the responsibility of you, the Customer.
Handling the antenna cable
Back
Route away from
the unit.
Back
Do not route
close to the unit.
Front
Do not pass
around the front of
the unit.
To avoid noise in the video, hold the antenna cable correctly.
Power On / Off
Preparation
Connect the mains lead.
Press the
switch on the unit to turn the set on.
Owner ID
setting screen is displayed. See page 14.
To switch the unit to Standby mode, press the
button on the remote control.
The unit can be switched on by pressing the
button
again if it was switched to Standby mode.
Power lamp (standby: red)
switch
Remote control
signal sensor