38
It is difficult to erase
drawings on the screen
film surface.
1. They were drawn fast.
2. They had been erased before the ink
dried completely.
3. Cleaners including a surface-active
agent were used.
1. Draw them slowly.
2. Erase them after the ink dries completely.
3. Clean the screen film surface with a water dampened-cloth
that has been thoroughly wrung.
A part of drawings on the
screen film surface
cannot be scanned.
A part of drawings is out of the
scanning area the unit (Panaboard)
allows to be scanned.
1. Refer to the scannable area on this unit (See Sec. 2.2),
then draw and scan again.
The scanned image is
blank, light or faint.
The density of the original drawings
is light or faint.
1. Make darker drawings or replace markers.
Black or white lines
appear on the scanned
image, or the scanned
image is dark or blank.
1. A dirt is attached to the lens surface
for scanning.
1. Wipe off the dirt from the lens surface.
2. This unit is exposed to direct
sun-light.
1. Change the location of the unit to avoid the light.
A USB Flash Memory
Device or SD Memory
Card is not recognized.
1. The USB Flash Memory Device or
SD Memory Card is not available for
this unit.
1. Check whether the device or card is available for the unit.
→
For information regarding available printers, refer to the
following site:
http://panasonic.co.jp/pcc/products/en/eboard/
ub- 5838c_info.htm
2. The USB Flash Memory Device is
connected via USB hub.
1. Don't connect the device via USB hub.
It takes a long time to
recognize a USB Flash
Memory Device.
The device has been never used since
it was formatted using FAT32.
1. Use the device once.
Stored image data in a
SD Memory Card is
rotated by 90 degrees.
The images were stored as JPEG.
1. Rotate them back to the original position with a graphic
software.
A PC does not recognize
this unit (Panaboard).
1.This unit (Panaboard) isn't set up
completely.
1. Wait for a while until the unit is set up perfectly.
2. Restart the unit.
2. A PC is not properly connected to
this unit (Panaboard).
1. Check whether the USB cable between the PC and the
unit is connected directly.
When turning on this unit,
the time set-up indication
is displayed.
The battery is reaching the end of its
life.
1. Change the battery and then set up the time.
Phenomenon
Possible Cause
Check Point
Summary of Contents for UB-5338C
