21
3.4.
Operation Check and Settings before using Panaboard
3.4.1.
Before Operation Check
Note:
1. Do not wipe the screen film surface with paint thinner,
benzene, or cleaners that contain abrasives. Doing so
may cause discoloration.
2. Do not wipe the screen film surface with a dry cloth.
Doing so may create static electricity.
3.4.2.
Setting the time
1.
Wipe the screen film surface.
• Soak a soft cloth with water, wring well, and wipe the screen
film surface.
2.
Attach the Power Cord.
• Securely fit the included Power Cord in the AC inlet of the
control box.
3.
Remove the battery protection sheet.
1.
Turn the power switch on.
• The time set-up screen is displayed automatically when the
power switch is turned on for the first time.
If the time set-up screen is not displayed even when the power
switch is turned on, push the Set-up Key on the Control Panel
to enter the setting mode, then push the Set-up Key (
)
repeatedly to select the time set-up mode, and then push the
Advance Key (
).
2.
Set the current time.
• The value can be changed by pushing the Set-up Key (
),
and select the setting by pushing the Advance Key (
).
3.
Push the Mode Key (
) to set the time.
Summary of Contents for UB-5838C
