Usage
15
1
Electronic Pen (Optional Device)
Notice
•
When operating the electronic pen’s up button, down button or menu/mode selector button, point
the penpoint at the elite Panaboard’s electronic pen signal receiver, and operate the button. For
the operating ranges of the electronic pen, refer to “Operating ranges of the electronic pen”
(page 16).
•
To use the electronic pen, switch to the Electronic Pen mode using the software.
(To use your finger, switch to the Finger/Stylus Pen mode.)
•
Confirm that the status LED lights when using the electronic pen.
•
To avoid operating errors, do not touch the penpoint when the electronic pen is not in use.
•
Use the electronic pen by bringing the penpoint into contact with the screen board.
The screen board may become dirty if the electronic pen is used by bringing its other end into
contact with the screen board surface.
•
Do not tap or knock the screen board with the electronic pen. Otherwise, it may cause malfunction.
Strap Loop
For attaching straps, if desired.
(Use a commercially available strap
from which the cord will detach if
excessive force is applied.)
Status LED (green)
Lights when the electronic pen power is
on.
Blinks when the electronic pen battery
is low.
Down Button
Performs the same function as pressing the Page
Down key on a computer by remote control.
Up Button
Performs the same function as pressing the Page Up
key on a computer by remote control.
Menu/mode selector button
Hold this button and touch the screen board with the
pen to display the Drawing Menu (page 24).
Press and release this button away from the elite
Panaboard to switch between the Finger/Stylus Pen
mode and the Electronic Pen mode (page 24).
Penpoint
Battery Cover
To attach/replace the battery, see “Replacing the
Battery in the Electronic Pen (Optional Device)”
(page 28).
Selector Dial
Selects features of the electronic pen.