39
9.2.
Error Message on PC
Note: *
Disassembling the unit will be required to remove the USB cable from the unit and/or reassemble it.
Symptom
Possible Cause
Check Point
1. "elite Panaboard
could not be found.
Confirm all
connections."
The connection between elite Panaboard
and PC is not proper.
*
1. Check the connection between the elite Panaboard and
PC.
2. Plug the USB cable to another USB interface on the PC.
The USB cable from the elite Panaboard
is connected to PC via a USB Hub.
1. Plug the USB Cable to the PC, directly.
The USB cable has a failure.
*
1. Replace the USB cable.
CONTROL Board has a failure.
1. Replace the elite Panaboard.
2. "elite Panaboard was
disconnected."
The connection between elite Panaboard
and PC is not proper.
*
1. Check the connection between the elite Panaboard and
PC.
2. Plug the USB cable to another USB interface on the PC.
The USB cable from the elite Panaboard
is connected to PC via a USB Hub.
1. Plug the USB Cable to the PC, directly.
The USB cable has a failure.
*
1. Replace the USB cable.
3. “A problem is
occurring concerning
the operation of the
elite Panaboard.
Check if there are any
magnets or other
obstructing objects on
the surface or frame of
the screen board.”
Magnets or similar objects have been
attached to the Screen Board.
Remove the magnets or other similar objects from the
Screen Board.
Summary of Contents for UB-T580
