•
Tighten the bolt so that it will not become loose.
•
When drilling the holes and installing the wall mounting plates, follow the procedure in "Wall Types and
Installation Procedures" (page 35).
5.
Mount the elite Panaboard on the wall.
See "Assembling the elite Panaboard" (For Wall Mounting
®
Wall Types and Installation Procedures
The method for attaching the wall mounting plates to the wall will vary depending on the wall's structure.
Three available options are listed below.
Other methods may be necessary depending on the wall.
Metal or Concrete walls
Stud plugs (not included) are needed.
Drill bit
Metal or concrete
wall
Stud plug
Wall mounting
plate
Bolt
Insert a stud plug in the hole.
Drill eight holes in the wall.
For the correct hole size, refer to the instruc-
tions for the particular stud plugs used.
Insert the bolt through the hole in the wall
mounting plate and tighten until the wall
mounting plate is securely fixed to the wall.
Operating Instructions (For Basic Operations)
35
1
Installation Manual
