Cautions for use
Oth
er
s
110
LSQT1048
Cautions for use
≥
The unit, disc and card become warm after
long operation, but this is not a malfunction.
Keep the unit away from magnetized
products/mobile phones, microwave ovens,
TVs and video game products.
≥
If you use the unit on or near a TV, the
images or sound may be disturbed due to
electromagnetic wave radiation.
≥
Do not use near cell phone because doing so
may cause noise to adversely affect the
picture and sound.
≥
Recordings may be damaged, or images may
be distorted, by the strong magnetic fields
created by speakers or large motors.
≥
Electromagnetic wave radiation generated by
digital circuits including microprocessors may
adversely affect the unit, causing the
disturbance of images and sounds.
≥
If the unit is affected by such products and
does not function properly, turn off the unit
and detach the battery or AC adaptor. Then
connect the battery or AC adaptor again.
Do not use the unit near radio transmitters
or high-voltage cables.
≥
If you record pictures near radio transmitters
or high-voltage cables, recorded images or
sounds may be adversely affected.
Make sure to use the supplied cords and
cables. If you use optional accessories, use
the cords and the cables supplied with
them.
Do not extend the cords and the cables.
Do not spray insecticides or volatile
chemicals onto the unit.
≥
If the unit is sprayed with such chemicals, its
body may be marred and the surface finish
may peel off.
≥
Do not leave rubber or plastic products in
contact with the unit for a long time.
When you use the unit in a sandy or dusty
place such as a beach, do not let sand or
fine dust get into the body and terminals of
the unit.
Also, keep the unit away from sea water.
≥
Sand or dust may damage the unit. (Care
should be taken when inserting and removing
a disc or a card.)
≥
If sea water splashes onto the unit, wipe off
the water with a well wrung cloth. Then wipe
the unit again with a dry cloth.
When carrying the unit, do not drop or
bump it.
≥
A strong impact can break the unit’s casing,
causing it to malfunction.
Do not use benzine, paint thinner or alcohol
for cleaning the unit.
≥
Before cleaning, detach the battery or pull out
the AC cable from the AC outlet.
≥
The camera body may be discoloured and
the surface finish may peel off.
≥
Wipe the unit with a soft dry cloth to remove
dust and fingerprints. To remove stubborn
stains, thoroughly wring a cloth that has been
soaked in a neutral detergent diluted with
water and wipe the unit with it. Afterwards,
wipe it with a dry cloth.
≥
When you use a chemical dust cloth, follow
the instructions that came with the cloth.
About this unit
LSQT1048(ENG).book 110 ページ ２００６年２月６日 月曜日 午後２時１３分
