Se
tup
Power supply
23
LSQT1048
≥
When recording, remove the lens cap before turning the unit on.
If the unit is turned on with the lens cap fitted, the automatic white balance adjustment may not
function properly.
While pressing the button
A
, set the
OFF/ON switch to ON.
The status indicator
B
lights red.
≥
The date and time display flashes. Set this. (
l
35)
While pressing the button
A
, set the OFF/ON switch to
OFF.
The status indicator
B
goes off.
Turning the unit on/off
How to turn on the power
A
B
How to turn off the power
A
B
When the power is turned on for the first time after changing the disc or battery, the unit carries
out a recognition procedure to check that there are no problems with the disc.
This takes approximately 25 seconds with DVD-RAM.
If you want to start using the unit as soon as you turn on the power, do the following.
1) Turn on the power.
2) After “READING DISC...” disappears from the screen, turn off the power.
You can start recording approximately 8 seconds after you turn on the power again.
≥
Depending on the condition of the disc, it may take longer than this.
≥
If the date and time are not set, this function does not work.
LSQT1048(ENG).book 23 ページ ２００６年２月６日 月曜日 午後２時１３分
