Troubleshooting
Oth
er
s
106
LSQT1180
Problem
Check points
The DISC EJECT lever
does not work.
≥
The disc cover will not open unless the unit is powered.
#
Connect a charged battery or AC adaptor.
The disc cannot be read.
≥
Are there fingerprints or dirt on the surface of the disc?
#
If there are fingerprints or dirt on the disc, wipe them off.
(
l
20)
A function indication
such as mode indication,
remaining time
indication, or elapsed
time indication is not
shown.
≥
If you set [SETUP]
>
[DISPLAY]
>
[OFF], indications other
than warnings and date indications disappear.
Recording does not start
although power is
supplied to this unit and
the disc or card is
correctly inserted.
≥
Is the DVD-RAM or the DVD-RW (VR format) write-
protected?
#
Release the protection. (
l
87) If the DVD-RAM or DVD-RW
(VR format) was protected on another device, release the
protection on the same device.
≥
Has the DVD-RW (Video format) or DVD-R been finalized?
#
After finalizing, the discs become play-only and cannot
record. If you un-finalize a DVD-RW (Video format), it can be
used for recording. (
l
86)
≥
Has the SD card’s write protect switch been set to LOCK?
#
No recording is possible while the write protect switch is set
to LOCK. (
l
19)
≥
Is the memory of the disc or card full?
#
If the disc or card has no more available memory, free up
some memory by deleting unnecessary scenes (
l
66, 79) or
use a new disc or card.
≥
Is the unit set to the disc recording mode or card recording
mode?
#
No recording is possible unless the mode dial is at
or
.
≥
Is the disc cover open?
#
If the cover is open, this unit may not operate normally. Close
the disc cover.
Recording starts but
stops immediately.
The playback picture
breaks up for a moment.
≥
Is the disc scratched or dirty?
#
Clean the disc. (
l
20)
≥
The unit is hot. Follow the messages on the display.
To use the unit again, turn the unit off and leave it for a
while.
LSQT1180(ENG).book 106 ページ ２００７年１月２９日 月曜日 午後３時２５分
