Panasonic Viera TC-L47DT50, Quick Setup Manual

7

CEA CHILD SAFETY NOTICES

WARNING

Flat panel displays are not always supported on the 
proper stands or installed according to the manufacturer’s 
recommendations. Flat panel displays that are inappropriately 
situated on dressers, bookcases, shelves, desks, speakers, 
chests or carts may fall over and may cause personal injury or 
even death. 

The consumer electronics industry (of which Panasonic is 
a member) is committed to making home entertainment 
enjoyable and safe. To prevent personal injury or death, be 
sure to follow the following safety guidelines: 

TUNE INTO SAFETY: 

•  One size does NOT fit all.  Follow the manufacturer’s 

recommendations for the safe installation and use of your 
flat panel display. 

•  Carefully read and understand all enclosed instructions for 

proper use of this product. 

•  Don’t allow children to climb on or play with furniture and 

television sets. 

•  Don’t place flat panel displays on furniture that can easily be 

used as steps, such as a chest of drawers. 

•  Remember that children can become excited while watching 

a program, especially on “larger than life”  flat panel 
displays.  Care should be taken to install the display where it 
cannot be pushed, pulled over, or knocked down. 

•  Care should be taken to route all cords and cables 

connected to the flat panel display so that they cannot be 
pulled or grabbed by curious children. 

WALL MOUNTING:

 IF YOU DECIDE TO WALL MOUNT 

YOUR FLAT PANEL DISPLAY, ALWAYS: 
•  Use a mount that has been recommended by the display 

manufacturer and/or listed by an independent  laboratory 
(such as UL, CSA, ETL). 

•  Follow all instructions supplied by the display and wall 

mount manufacturers. 

•  If you have any doubts about your ability to safely 

install your flat panel display, contact your retailer about 
professional installation. 

•  Make sure the wall where you are mounting the display 

is appropriate.  Some wall mounts are not designed to 
be mounted to walls with steel studs or old cinder block 
construction.  If you are unsure, contact a professional 
installer. 

•  A minimum of two people are required for installation.  Flat 

panel displays can be heavy. 

Panasonic recommends that a qualified installer perform 

the wall-mount installation. See page 8.

The American Academy of Pediatrics discourages media 

viewing for children younger than two years. For more 

details, see www.aap.org.

■

When setting up the TV

• Two people are always required.
• For workers’ safety, be sure to follow the assembly procedure on page 9 when attaching the pedestal.

Failure to do this may also result in damage of the inside of the LCD panel.

■

When moving the TV

• The TV should be kept upright and held by two people when it is moved.
• Moving the TV with the LCD panel facing up or down may result in damage of inside of the LCD panel.

■

About  built-in wireless LAN/Bluetooth

●

To use the built-in wireless LAN, an access point needs to be obtained.

●

Do not use the built-in wireless LAN to connect to any wireless network (SSID*

1

) for which you do not have usage 

rights. Such networks may be listed as a result of searches. However, using them may be regarded as illegal access.

●

Check that the Access point supports WPS*

2

.

(If it does not support WPS, the encryption key of the Access point is required when configuring settings.)

●

Follow the instructions on the Access point setup screen and configure the appropriate security settings.
For more details on setting of Access point, please refer to operating manual for the Access point.

●

We recommend using 11n (5 GHz) for the wireless system between the built-in wireless LAN and Access point.
Communication is also possible with 11a, 11b, and 11g (2.4 GHz), but the communication speed may be slower.

●

If the wireless system of the Access point is changed, devices that could connect by wireless LAN may no longer be 
able to connect.

●

Data transmitted and received over radio waves may be intercepted and monitored.

●

Keep the TV away from the following devices as much as possible:
Wireless LAN, microwaves, and other devices that use 2.4 GHz and 5 GHz signals. Otherwise, the TV failures such 
as malfunction may occur due to the radio wave interference.

●

When noises occur due to the static electricity, etc., the TV might stop operating for the protection of the devices. In 
this case, turn the TV Off with power On / Off switch, then turn it On again.

*

1

 SSID is a name for identifying a particular wireless network for transmission.

*

2

 WPS: Wi-Fi Protected Setup

tc̲L47̲55̲dt50̲eng̲0652.indb   7

tc̲L47̲55̲dt50̲eng̲0652.indb   7

2012/02/14   18:03:42

2012/02/14   18:03:42