37
Advanced
Editing and Setting Channels
Automatically searches and adds available channels to the memory.
Select “ANT in”
Select “Cable” or “Antenna”
or select “Not used” (p. 15).
Select “Auto program”
Menu
Cable
ANT/Cable setup
ANT in
Auto program
Manual program
Signal meter
next
select
Select a scanning mode
(p. 15)
Menu
Auto program
All channels
Analog only
Digital only
OK
select
Settings are made automatically
After the scanning is completed, select “Apply”.
(see below
).
All previously saved channels are erased.
Use this procedure when changing the channel setup or
changing the channel display.
Also, use this to add or skip channels from the channel list
manually.
You can select a channel tuning mode (Digital only/Analog
only) in “Channel surf mode”(p. 27)
Edit
Caption
---
80-101
Edit CH caption
Caption
Channel
OK
RETURN
Delete
ABC
→
abc
R
G
B
Y
Select
@ D A
change
set
or
Caption
Select or edit the station identifier.
(maximum 7 characters available)
Favorite
Set favorite
1/3
26-1
1
2
select
set
Set favorite
Select the number
Add
Press OK to select “Yes (add)” or “No (skip)”
Move the cursor to a channel number
Manual program
Edit
Cancel
Apply
Caption
Favorite
Add
2
...
...
Yes
3
...
...
Yes
Channel
select
press OK to tune
to the channel
Select “Apply”
program
Cancel
Apply
Caption
Favorite
Add
...
...
Yes
el
select
OK
Select “Edit”
Manual program
Edit
Cancel
Apply
Caption
Favorite
Add
2
...
...
Yes
3
...
...
Yes
4
...
...
Yes
5
...
...
Yes
Channel
select
next
Select the item to edit
R
G
B
Y
Select
RETURN
OK
Manual program
Edit
Cancel
Apply
Caption
Favorite
Add
2
...
...
Yes
3
...
...
Yes
4
...
...
Yes
5
...
...
Yes
6
...
...
Yes
7
...
...
Yes
8
...
...
Yes
9
...
...
Yes
Channel
Prev.page
Next page
Caption
Favorite
Add
Proceed to
next page
Go back to the previous
page
select the item
to edit (Caption/
Favorite/Add)
next
•
Caption:
Changes the station identifier
•
Favorite:
Registers channels to the
Favorite List
•
Add:
Adds or skips channels
To cancel the Edit
Manual program
Edit
Cancel
Apply
Caption
Favorite
Add
2
...
...
Yes
3
...
...
Yes
4
...
...
Yes
5
...
...
Yes
Channel
select
next
Changes will be lost. Continue?
Yes
No
OK
(returns to “ANT/
Cable setup”)
select “Yes”
Check the signal strength if interference is found or freezing occurs on a digital image.
Menu
Selects which channel to be tested for signal
strength.
--
Signal meter
Channel
Signal strength
Current
86%
Peak level
98%
change
channel
OK
or
Signal intensity
If the signal is weak, check the antenna.
If no problem is found, consult your local dealer.
Note
Not available if “Cable” is selected in “ANT in” (see above).
Available only for digital antenna channels.
If “Lock” (p. 34) is activated and “ANT/Cable setup” is selected, “Enter password.” will be displayed.
tc̲p58̲65̲s2̲eng̲0587.indb 37
tc̲p58̲65̲s2̲eng̲0587.indb 37
2010/03/23 14:26:52
2010/03/23 14:26:52
