Connecting the TV
|
Initial Setup
8
Speaker system
HDMI cable
Amplifier with
speaker system
TV
●
Use HDMI 2 for connecting an amplifier that has ARC
(Audio Return Channel) function.
For an amplifier without ARC function, use DIGITAL
AUDIO OUT.
●
To enjoy the sound from the external equipment in
multi-channel sound (e.g. Dolby Digital 5.1ch), connect
the equipment to the amplifier. For the connections,
read the manuals of the equipment and amplifier.
Initial Setup
When you first turn on the TV, a series of steps will pop-
up to guide you to setup your TV.
●
These steps are not necessary if the setup has been
completed by your local dealer.
1
Plug the mains plug into the mains
socket and turn on the TV.
It may take a few seconds before the screen is
displayed.
AC 220 - 240 V,
50 / 60 Hz
Proceed to steps 2, 3 and 4.
Scanning starts automatically when
you turn on the TV (step 3). After scanning is
completed, proceed to step 4.
2
Select your area.
New South Wales/Australian Capital Territory
Victoria
Queensland
South Australia
Western Australia
Northern Territory
Tasmania
Select State/Territory
OK
Access
Select
3
Scanning starts.
[Automatic Channel Search]
[Auto Tuning]
Example:
Automatic Channel Search
Status: Scanning...
Analogue : 0
Digital : 1
EXIT
RETURN
Scan
5%
●
This function searches and stores TV channels.
●
The stored channels and sorted channel order vary
depending on the area, broadcasting system and
conditions of signal reception.
4
Select [Home].
Please select your viewing environment.
Home
Shop
OK
Confirm
Change
●
[Shop] is for shop display.
●
To change the viewing environment later on, you
need to initialise all settings by accessing [Shipping
Condition]
(p. 16).
Setup is now complete and your TV is ready for
viewing.
Note
●
If tuning has failed, check the connection of the
RF cable, then follow the on-screen instructions.
