29
7. Remove the screws (
×
2 ).
8. Remove the K-Board and disconnect the connector (K1).
7.38. Remove the GL-Board
1. Remove the Cabinet assy. (See section 7.25.)
2. Remove the Speaker (Squawker /R). (See section 7.34.)
3. Remove the Bottom shield L. (See section 7.36.)
4. Remove the screws (
×
5
) and remove the Bottom
shield R.
5. Remove the screws (
×
8
) and remove the Bottom
plate.
6. Remove the screws (
×
2
) and remove the GL-Board
and disconnect the connector (GL02).
7.39. Replace the plasma panel (fin-
ished)
1. Place the new plasma panel (finished) on the flat surface
of the table (covered by a soft cloth), with the plasma
panel surface facing downward.
2. Attach the C1, C2, C3,C4,C5-Board and the C6-Board,
connect the flexible cables (
×
30) from the Plasma panel
to the C1, C2, C3,C4,C5-Board and the C6-Board, and fit
the flexible cable holders.
3. Attach the Hooks (left, right) and fit the Vertical Bar (L, R)
and the V-Bar fixing metal (A, B, C, D) to the new plasma
panel.
4. Place the plasma panel section on the servicing stand.
5. Attach the cabinet assy and each P.C.Board and so on, to
the new plasma panel.
* When fitting the cabinet assy, be careful not to allow
any debris, dust or handling residue to remain
between the front glass and plasma panel.
Summary of Contents for Viera TH-65PY800P
