Frequently Asked
Questions
d
s
69
Problem
Actions
Screen
Chaotic image, noisy
●
Change the setting of [P-NR] in the Picture Menu (to remove noise).
(p. 24)
●
Check nearby electrical products (car, motorcycle, fluorescent lamp).
No image can be
displayed
●
Is [Colour] or [Contrast] in the Picture Menu set to the minimum?
(p. 24)
Blurry or distorted
image
(no sound or low
volume)
●
Reset channels
(p. 31)
Unusual image is
displayed
●
Turn the TV Off with Mains power On / Off switch, then turn it On
again.
Sound
No sound is produced
●
Is “Sound Mute” active?
(p. 11)
●
Is the volume set to the minimum?
Sound level is low or
sound is distorted
●
Sound signal reception may be deteriorated.
●
Set [MPX] in the Sound Menu to [Mono]
(p. 27)
HDMI
Sound is unusual
●
Set the sound setting of the connected equipment to “2ch L.PCM”.
●
Check the [HDMI1 / 2 / 3 Input] setting in the Sound Menu.
(p. 27)
●
If digital sound connection has a problem, select analogue sound
connection.
(p. 62)
Pictures from external
equipment are unusual
when the equipment is
connected via HDMI
●
Check that the HDMI cable is connected properly.
(p. 53, 58 - 60)
●
Turn the TV and equipment Off, then turn them On again.
●
Check the input signal from the equipment.
(p. 63)
●
Use an equipment compliant with EIA/CEA-861/861B.
Network
Cannot connect to the
network
●
Check that the LAN cable or Wireless LAN Adaptor is connected
properly.
(p. 45)
●
Check the connections and settings.
(p. 46 - 48)
●
Check the network equipment and network environment.
●
If the problem persists, consult your Internet Service Provider or
telecommunications company.
Cannot select the
file during DLNA
operations
●
Is media server prepared?
(p. 44)
●
Check applicable data format.
(p. 65 - 66)
Cannot access the
Internet contents
●
Check the connections and settings.
(p. 46 - 48)
●
The server or connection line might be busy now.
Other
The TV goes into
Standby mode
●
Auto power standby function is activated.
●
The TV enters Standby mode about 30 minutes after analogue
broadcasting ends.
The remote control
does not work or is
intermittent
●
Are the batteries installed correctly?
(p. 8)
●
Has the TV been switched On?
●
Point the remote control directly at the front of the TV
(within about 7 m and a 30 degree angle from the front of the TV).
●
Place the TV away from sunshine and do not let other sources of
bright light to shine on the TV’s remote control signal receiver.
TH_L42U30KMTX_EN.indd 69
TH_L42U30KMTX_EN.indd 69
3/21/2011 1:43:11 PM
3/21/2011 1:43:11 PM
