Problem
Actions
Screen
Chaotic image, noisy
u
Set “P-NR” in the Picture Menu (to remove noise). (p. 22)
z
Check nearby electrical products (car, motorcycle, fluorescent lamp).
z
No image can be displayed
u
Is “Colour” or “Contrast” in the Picture Menu set to the minimum?
z
(p. 22)
Blurry or distorted image
(no sound or low volume)
u
Reset channels. (p. 27)
z
Unusual image is displayed
u
Turn off the TV with Mains power On / Off switch, then turn it on
z
again.
Sound
No sound is produced
u
Is “Sound mute” active? (p. 9)
z
Is the volume set to the minimum?
z
Sound level is low
or sound is distorted
u
Sound signal reception may be deteriorated.
z
Set “MPX” (p. 22) in the Sound Menu to “Mono”.
z
HDMI
Sound is unusual
u
Set the sound setting of the connected equipment to “2ch L.PCM”.
z
Check the “HDMI1 Input” setting in the Sound Menu. (p. 22)
z
If digital sound connection has a problem, select analogue sound
connection.
Pictures from external equipment are
unusual when the equipment is
connected via HDMI
u
Is the HDMI cable connected properly? (p. 40)
z
Turn Off the TV and equipment, then turn them On again.
z
Check an input signal from the equipment. (p. 44)
z
Use an equipment compliant with EIA/CEA-861/861B.
z
Other
TV goes into
“Standby mode”
u
Off Timer function is activated.
z
The TV enters “Standby mode” about 30 mins. after broadcasting
z
ends.
The remote control
does not work
u
Are the batteries installed correctly? (p. 6)
z
Has the TV been switched On?
z
FAQs
46
