Auto T
uning
17
6
Select the connection type
Please select network connection type.
Connection Type
Search for access point
WPS(Push button)
select
access
●
If your access point supports WPS (Push
button), then select this option. If not,
select [Search for access point].
[WPS(Push button)]
1. Press the WPS button on the access point until the light flashes
2. Connect the Wireless LAN Adaptor and the access point
1) Please press the ‘WPS’ button on the access
point until its light flashes.
2) When the light is flashing select ‘Connect’ on
TV.
If you are unsure, please check the instruction
manual of the access point.
1) Please press the ‘WPS’ button on the access
point until its light flashes.
2) When the light is flashing select ‘Connect’ on TV.
If you are unsure, please check the instruction
manual of the access point.
WPS(Push button)
Connect
●
Ensure that your access point supports WPS for this setup.
●
WPS: Wi-Fi Protected Setup™
●
If the connection has failed, check the settings and positions of
your access point. And then, follow the on-screen instructions.
3. After the access point setting is finished, perform the connection test
Check access point connection.
Check acquired IP address.
Check for devices using same IP address.
Check gateway connection.
Connection Test
: succeeded
The test is successful and the TV is connected to
the network.
: failed
Check the settings and connections. And then try
again.
4. Go to the next step
(Press twice)
[Search for access point]
Access points found automatically are listed.
1. Select your desired access point
1
2
3
Access Point A
Access Point B
Access Point C
11n(2.4GHz)
11n(5GHz)
11n(5GHz)
Available Access Points
Encrypt
No.
SSID
Reception
Wireless type
select
access
●
To search access points
again
Y
: Encrypted access point
●
For the information of the
highlighted access point
INFO
2. Access the encryption key input mode
Encryption Key Setting
Connection will be made with the following settings:-
SSID : Access Point A
Encryption key
Authentication type : WPA-PSK
Encryption type : TKIP
Please input the encryption key.
●
If the selected access point is not encrypted, the confirmation
screen will be displayed. It is recommended to select the
encrypted access point.
3. Enter the encryption key of the access point
A B C D E F G H
I
J K L M N O P Q R S T
U V W X Y Z
0 1 2 3 4 5 6 7 8 9
!
:
#
a b c d e
f
g h
i
j
k
l m n o p q
r
s
t
u v w x
y
z
(
)
+
-
.
*
_
Access Point Settings
Encryption key
Set characters
Store
select
set
RETURN
●
You can set characters by using numeric buttons.
(p. 78)