F
AQs, etc.
•
Frequently Asked
Questions
37
Problem
Actions
Screen
Sound
HDMI
Chaotic image, noisy
•
Set "P-NR" in the Picture menu (to remove noise).
(p. 16)
•
Check nearby electrical products
(car, motorcycle, fl uorescent lamp).
No image can be
displayed
•
Is "Colour" or "Contrast" in the Picture menu set to the
minimum? (p. 16)
Blurry or
distorted image
(no sound or low volume)
•
Reset channels. (p. 20)
Neither image nor
sound is produced
•
Is the TV in "AV mode"?
•
Is the mains lead plugged into the socket outlet?
•
Is the TV turned On?
•
Check Picture menu (p. 16) and volume.
No sound is produced
•
Is "Sound Mute" active? (p. 7)
•
Is the volume set to the minimum?
Sound is unusual
•
Set the sound setting of the connected equipment
to "2ch L.PCM".
•
Check the "HDMI1 input" setting in the Sound menu. (p. 16)
•
If digital sound connection has a problem, select analogue
sound connection. (p. 33)
Sound level is low
or sound is distorted
•
Sound signal reception may be deteriorated.
•
Set "MPX" (p. 16) in the Sound menu to "Mono".
An error message
appears
•
Follow the message's instructions.
•
If the problem persists, contact the authorized Service Centre.
An error message appears
•
Contact the authorized Service Centre.
“Control with HDMI”
function does not work
•
Switch the TV on again with the equipment on.
•
Set “Control with HDMI” to “Off”, then set to “On” again.
(p. 27)
The SD card cannot be
used even when it is
formatted
•
Contact the authorized Service Centre.
Other
SD
TV goes into
"Standby mode"
•
The sleep function is activated.
•
The TV enters "Standby mode" about 30 min. after
broadcasting ends.
