Introduction
This product is an additional product designed to be used with the following Panasonic Video Intercom
Systems.
– VL-SWD501AZ/VL-SWD501UAZ (Main monitor station: VL-MWD501BX)
(The corresponding models are subject to change without notice.)
R
By installing this product, you can extend the range of your Video Intercom System to include areas
where reception was previously not available.
The product extends the range in all directions, allowing several floors to be covered.
R
You must register this product with your Video Intercom System before it can be used.
R
Keep an appropriate distance from the main monitor to maximise the range of your Video Intercom
System. Find the appropriate location by checking the
ID
indicator after registering this product with
your Video Intercom System. If the
ID
indicator lights red or orange, re-position this product in a
place where the
ID
indicator lights green.
E
A
B
C
D
A
Main monitor
B
Repeater
C
Device you want to
connect to (sub monitor or
camera)
D
Main monitor range
E
Repeater range
R
When used with the Video Intercom System VL-SWD501AZ series, a maximum of 2 repeaters can be
used. Because the number of repeaters that can be used may differ depending on the Video Intercom
System series used, see the Operating Instructions of the Video Intercom System for more information.
R
The illustrations in the supplied manual(s) may vary slightly from the actual product.
Product names used in this manual
Model No.
Product name
Name in this manual
VL-FKD2AZ
DECT repeater
Repeater
VL-MWD501BX
Main monitor station
Main monitor
VL-WD613AZ
Wireless monitor station
Sub monitor
VL-WD812AZ
Wireless sensor camera
Camera
*1 The product label reads as follows: VL-FKD2EX/VL-WD613BX/VL-WD812EX
2
