18
3
Panel/Floor Heater Piping Installation
• It’s strongly recommended to install an expansion vessel
(purchase seperately) in the water circuit. Refer
Typical
piping installation
section to locate the expansion vessel.
• The capacity of the expansion vessel should be given by
formula.
• Connect Tank Unit tube connector
E
(indicated with
“PANEL/FLOOR (OUT)”) to inlet connector of Panel/Floor
heater.
• Connect Tank Unit tube connector
F
(indicated with
“PANEL/FLOOR (IN)”) to outlet connector of Panel/Floor
heater.
• Failure to connect the tube appropriately might cause the
Tank Unit malfunction.
4
Drainage Piping Installation
• Use a drain hose with inner diameter of 15 mm.
• The hose must be installed in a continuously downward
direction and left open to the frost-free atmosphere.
• If drain hose is long, use a metal support fixture along the
way to eliminate the wavy pattern of drain tube.
• The water may drip from this discharge hose. Therefore
must guide the hose without close or block the outlet of the
hose.
• Do not insert this hose into sewage hose or cleaning hose
that may generate ammonia gas, sulfuric gas etc.
• If necessary, use a hose clamp to tighten the hose at drain
hose connector to prevent it from leaking.
• Guide the drain hose to outdoor as illustrated at the right
figure.
5
Water Discharge Piping Iinstallation
• Use 1/2” male connector for discharge valve connection.
Refer to
Main components diagram
section for the location
of discharge valve.
• Piping must to be installed in a continuously downward
direction and in a frost-free environment.
• Discharge pipes must be visible and away from electrical
components.
Summary of Contents for WH-TX30B9E8
