Secure fan body
Sealing
2
A
Flange
2 Self-drilling screws (fasten the
flange and Flex-Z Fast™ bracket
through the drywall)
Drywall
Plug connector
Receptacle
Machine screw (M4X8)
1
Joist
1
Joist
Joist
Secure the fan body to Flex-Z Fast™ bracket
by using 2 self-drilling screws.
Plug connector into receptacle and secure fan
body to adaptor by using machine screw (M4X8).
1
2
1
Adjust Pick-A-Flow™ switch. (Refer to
explanation under FEATURES). (Page 6)
2
Once fan body is mounted and secure, fill gap
between flange and ceiling with caulk or other
sealant to prevent air leakage.
Please take care when installing the machine screw (Step 6) to avoid cross threading and to ensure that the
screw does not strip or come in contact with the Flex-Z Fast™ bracket.
Insert the mounting springs into the slot as
shown to mount grille to fan body.
2
Connect the LED lamp wire to receptacle.
1
Install grille
CAUTION
IMPORTANT:
Remove the tape placed on the damper and
adaptor before installation. Failure to do so
will cause the product to work inefficiently and
create a loud noise.
If you require use of the 3 inch duct
reducer (optional accessory), use the
following method:
Insert
Duct tape
Adaptor
Damper
Tape
WARNING
Disconnect power supply before
installing the unit.
Please wear gloves to protect hands
during the installation.
Ensure the junction box cover encloses
all the wires and is completely flush
before locking in place with the attached
screw.
Drywall
Mounting spring
Gloves
Grille
LED lamp
wire
Receptacle
1
8
2
INSTALLATION (NEW CONSTRUCTION)
INSTALLATION (RETROFIT) (CONTINUED)
