●
Among the 3 screens above, the last
one displayed will appear when the screen
is started up the next time.
復旧/警報音停止
RESET/ STOP ALARM
OPEN
電源
火災
POWER
FIRE
留守
警戒
戸締り
NOTHOME
ガス
GAS
SET
復旧/警報音停止
RESET/ STOP ALARM
OPEN
電源
火災
POWER
FIRE
留守
警戒
戸締り
NOTHOME
ガス
GAS
SET
Total electric energy meter
To the electrical power grid
Measures the sales
and purchase of
electric energy with
the power company.
72
73
About the Energy Saving Monitor
Before use, set the electricity charges etc., in the eco-settings ( Page 126).
You can check the electricity consumption status and energy saving achievement level etc.
System configuration example
D Series
Measurement Box
Gas meter with
pulse transmitter
Pulse transmitting
flow meter (water supply)
Viewing the Energy Saving Monitor Screen
●
The Top Menu screen appears.
You can check the current electricity consumption status at a single glance.
There are 3 types of screens available - bubble display, simple display, and penguin display.
1
Press the MENU button in
the waiting state (nothing is
displayed on the screen)
2
Touch
Press
Eco Screen Selection screen
3
Confirm
( Pages 74 to 77)
Press the OFF button after the operation ends
4
●
The Energy Saving Monitor screen appears.
●
Bubble screen
●
Simple screen
●
Penguin screen
Note
Note
INTRODUCTION
USUAL USAGE
SETTING ACCORDING TO
YOUR PREFERENCES
OPERATIONS AND MEASURES
WHEN ALARM GOES OFF
SECURITY ALARM SETTING
AND DISARMING
RECORD
MANAGEMENT
OTHER
●
The operation is available when the D Series Measurement Box is used.
●
Use this after checking whether each device has been connected or not.
●
Only the main electric power can be measured.
●
The water consumption volume can be measured if a pulse transmitting flow meter (water
supply) is installed. (Check with the management company or installer for details.)
●
The gas consumption volume can be measured if a gas meter with a pulse transmitter is
installed. (Check with the management company or installer for details.)
●
If the time is not set correctly, the measured data cannot be obtained or displayed correctly.
(The time can be set with the lobby phone, building manager room base unit, or integrated
control panel. ( Page 11))
●
If the lobby phone, building manager room base unit, or integrated control panel is not
connected, the system cannot be used in a residential connection system in which the time
cannot be set.
●
Based on the data of the measured power, water and gas consumption volume, the consumed
volume and the estimated charges are displayed to show the energy saving effect in an intuitive
manner. Since these are estimated values, they may not tally with the consumed volume and
amount indicated in the invoice from the power company, water utility, or gas company and so
on. (The measurement accuracy of the power consumption volume is ±5
%
.) Note in advance
that the difference in the amount will not be guaranteed. In addition, if the tariff setting deviates
greatly from the subscription details of the power company, water utility, or gas company and so
on, a large difference in the actual amount from the estimated charges will result. Set the
charges as close to the tariff plan of your subscription as possible. ( Pages 127 to 137)
Note
Touch
●
If you are using a residence distribution board
with over-currency alarm (data output type)
(5 level display type), the Eco Screen
Selection screen will appear.
Touch .
Base unit
Residential
distribution panel
MENU button
Selection screen
●
The Selection screen may appear depending
on the equipment of the condominium you are
living in. Touch .
●
It will return to the waiting state (nothing is displayed on the screen).
The screen will automatically turn off when no operation is performed for 30 seconds.
(For base unit)
(For base unit)
Touch
Touch