[Access interval]
Select the interval to access the “Viewnetcam.com” service server to check the IP address and the host name
from the following.
10min/ 20min/ 30min/ 40min/ 50min/ 1h
•
Default:
1h
[Global IP Address Notification Method]
Typically [Global IP Address Notification Method] should be set to “Normal”.
If you cannot access the unit using the registered URL 30 minutes after registering with “Viewnetcam.com”,
select “Advanced”.
In this case, UPnP (
®
page 70) must be enabled for the unit and for the router.
•
Default:
Normal
13.4.3 Procedure to register information for the
“Viewnetcam.com” service
There are 2 methods to configure the “Viewnetcam.com” service.
•
Configure from the [Internet] tab of the “Basic” page:
“UPnP (Auto port forwarding)” and “Viewnetcam.com” can both be configured on the [Internet] tab.
•
Configure from the [DDNS] tab of the “Network” page:
Only “Viewnetcam.com” can be configured on the [DDNS] tab.
Configuring from the [Internet] tab of the “Basic” page
1.
Click the [Internet] tab of the “Basic” page.
2.
Select “On” for “UPnP (Auto port forwarding)”, and select “Viewnetcam.com” for “DDNS”, then click [Set].
94
Operating Instructions
13 Configuring the network settings [Network]
