66
8
Panic
Selecting “ ” (Panic) in the Search menu starts panic recording of all cameras, and selecting “ ” again
stops panic recording. It is the same as pressing the [PANIC] button.
9
Camera Menu
p
p
EL-Zoom:
Selecting “ ” (Camera Menu) → “EL-Zoom” and choosing the camera number zooms the
current playback image of the selected camera on the screen. It is the same as pressing the [EL-ZOOM]
button. Selecting “EL-Zoom” again exits the EL-Zoom mode.
p
p
Audio:
Selecting “ ” (Camera Menu) → “Audio” toggles audio playback On and Off. Recorded audio will
be played when the recorder displays a camera with recorded audio in full screen mode.
p
p
Show/Hide Text-In:
Selecting “ ” (Camera Menu) → “Show Text-In” or “Hide Text-In” shows or hides the
text-in data on the screen if the video was recorded with text-in data.
p
p
Edit Group:
Selecting “ ” (Camera Menu) → “Edit Group” enters to the Edit Group mode. It is the same
as pressing and holding the [EDIT GROUP] button for three seconds or longer in any multiview formats.
Refer to the previous “Live Monitoring – Edit Group Mode” section for details.
Note: The “Camera Menu” also can be displayed by clicking the right mouse button on the screen
while in the search mode.
:
Export
p
p
A–B Clip-Copy:
Selecting “ ” (Export) → “A–B Clip-Copy” will set the starting point of the video to be
clip copied, and the icon displays at the bottom-left corner of the screen. Selecting “A–B Clip-Copy”
again will set the ending point of the video to be clip copied and displays the “Clip-Copy” screen. See the
following “Clip-Copy” section for details.
p
p
Clip-Copy:
Select “ ” (Export) → “Clip-Copy”, and the “Clip-Copy” screen appears to allow clip copy
setup. See the following “Clip-Copy” section for details.
;
Status
Selecting “ ” (Status) in the Search menu allows you to check the status of the recorder’s system, inputs
and storage. Refer to the previous “Live Monitoring – Event Status” section for details.
<
Data Source
Selecting “ ” (Data Source) in the Search menu allows you to select the data source to be searched.
Selecting “Record” searches recorded data on primary storage installed in the recorder, and selecting “Other”
searches recorded data on storage used for another recorder then installed in this recorder.
=
Exit
Selecting “ ” (Exit) in the Search menu exits the search mode and enters the live monitoring mode.
