18
9
Monitor Output Connector
(VGA)
A VGA connector is provided so that you can use a standard, multi-sync
computer monitor as your main monitor. Use the cable supplied with your
monitor to connect it to the recorder.
Connect the spot monitor to the [SPOT] connector as needed.
Note: Connect the monitor before the recorder boots so that video can be displayed on the monitor
with the resolution you have set during system setup.
:
Network Port
The recorder can be networked using the 10/100/1000 Mbps Ethernet connector. Connect
a Cat5 cable with an RJ-45 jack to the recorder connector. The recorder can be networked
with a computer for remote monitoring, searching, configuration and software upgrades. See
“Chapter 3 ─ Configuration” for configuring the Ethernet connections.
Important: The network connector is not designed to be connected directly with cable or wire
intended for outdoor use.
;
Power Inlet
Connect the provided AC power cord to the recorder and then to a wall outlet.
WARNING: ROUTE POWER CORDS SO THAT THEY ARE NOT A TRIPPING HAZARD. MAKE CERTAIN
THE POWER CORD WILL NOT BE PINCHED OR ABRADED BY FURNITURE. DO NOT
INSTALL POWER CORDS UNDER RUGS OR CARPET.
THE POWER CORD HAS A GROUNDING PIN. IF YOUR POWER OUTLET DOES NOT HAVE
A GROUNDING PIN RECEPTACLE, DO NOT MODIFY THE PLUG. DO NOT OVERLOAD THE
CIRCUIT BY PLUGGING TOO MANY DEVICES IN TO ONE CIRCUIT.
Your recorder is now ready to operate. Refer to “Chapter 3 ─ Configuration” and “Chapter 4 ─ Operation”.