30
31
Set up the method of camera installation [Upside-down]
Select the method of installation for each camera and transmit the information to the cameras to change the
camera settings.
Clicking the [Setup >] button for " Upside-down " on the [Camera setup] tab will display the setup window.
[Upside-down]
On (desktop): Select this when the camera is to
be installed with the dome side up.
Off (ceiling): Select this when the camera is to be
installed with the dome side down.
Wall: Select this when the camera is to be
installed on a wall.
■
Camera Selection
Select the camera to which the setting of the
"Upside-down" is to be sent.
Mark the checkbox of the camera to which the setup
information is to be transmitted.
[Transmission] button
Transmit the setting of the "Upside-down" to the
camera.
Once transmission is completed and the setting has
been applied to the camera, "OK" will be displayed in
the "Results" field.
If the display reads "Authentication error", etc., the
camera connection or the setting may have failed.
[Back] button
Click the button after completing the settings.
The screen returns to the [Camera setup] tab.
Note:
To flip the camera image vertically, select the "Off
•
(ceiling)".
If a fisheye camera is registered, "Off (ceiling)" will
•
be set. Select "Wall" to install the camera on the
wall.
