10
MAJOR OPERATING CONTROLS AND THEIR FUNCTIONS
q
Power Indicator (OPERATE)
This indicator lights up when the power of the
encoder is on.
When the temperature inside the encoder becomes
remarkably high, this indicator will start blinking.
It will take around 2 minutes and 45 seconds to start
up the encoder after turning the power on.
During start up, the STATUS indicators (STATUS 1 -
5) will light up in order. When the STATUS 5
indicator lights up, it is possible to operate the
encoder.
Each STATUS indicator will light, blink or go off
according to the status of this encoder.
w
Status Indicators (STATUS 1 - 8)
STATUS 1 - 4:
These indicators display the status of
VIDEO 1 - 4.
Each of the STATUS 1 - 4 indicators displays the
status of the VIDEO IN 1 - 4 connectors
respectively. The indicators will light up when this
encoder is sending streaming data after encoding
a video signal from the respective VIDEO IN
connector. The indicators will go off when the
encoder is not sending streaming data (stops
encoding) even if a video signal is supplied to the
VIDEO IN connector. The respective indicator of
the VIDEO IN connector with no video signal will
blink.
STATUS 5 (RUN):
This indicator lights up when the
encoder is operable.
OPERATE
STATUS
MPEG2 Encoder WJ-GXE
900
1
2
3
4
5
6
7
8
OPERATE
STATUS
SW1
ON
A
B
C
SW2
RESET
WJ-GXE900
1
2
3
4
5
6
7
8
BLINKING TEMPERATURE WARNING
BLINKING TEMPERATURE WARNING
q
w
e
r t
STATUS 6 (LINK2):
This indicator lights up when the
initialization of the software has been completed
correctly, and the encoder can be connected to a
network.
STATUS 7 (RCV):
This indicator lights up when the
encoder is receiving packets (camera control,
serial data, etc.) except for video and audio
packets.
STATUS 8 (XMT):
This indicator lights up when the
encoder is sending packets (serial data, etc.)
except for video and audio packets.
e
Rotary Switch (SW1 A, B, C)
Use these switches to set the IDs of devices when
the Main CPU exists.
(4096 combinations for IDs can be made from 000 to
FFF.)
The default setting is "000".
Note:
The Main CPU mode is the advanced function
for integrated control. Use these switches with
the default settings for normal use.
r
Dip Switches 1 - 8 (SW2)
The settings of the these switches will be valid when
the encoder has started up.
Note:
When this switch is set to ON, the selected
actions will be performed each time on the
encoder power is turned on.
MPEG2 Encoder Front Panel
MAJOR OPERATING CONTROLS AND THEIR FUNCTIONS
Summary of Contents for WJGXD900 - MPEG2 DECODER
Page 101: ...101 ...
Page 118: ...118 ...
