49
RESET/TIMER (SEC) 1 - 60, 90, 120, 150, 180, 240,
300 - 3 600: 60 SEC INTERVAL
When the alarm is reset, the bit rate returns to the
set value on the VIDEO page and the alarm status is
released.
Select the method of release from the following.
CGI RESET
Resets the alarm using the CGI commands.
Refer to "RESETTING THE ALARM/DISPLAYING
THE ALARM STATUS" of the "HOW TO USE THE
CGI COMMANDS" section on page 102.
ALARM OFF TIMING
Resets the alarm at the timing as follows:
• Timing of a closed contact is opened if "OPEN" is
selected for "MAKE CONTACT".
• Timing of an open contact is closed if "CLOSE" is
selected for "MAKE CONTACT".
TIMER
The timer starts when the alarm is detected. When
the entered time for this setting has past, the alarm
will be reset automatically. Select the time (seconds)
from the following.
1 - 60 (a second step), 90, 120, 150, 180, 240, 300 -
3 600 (60 seconds interval)
Notes:
• When an alarm with the same alarm type and
number is detected and the timer is activated, the
timer resumes from the set value.
• When alarms are detected successively, the
encoder is controlled by each alarm.
The default setting is "TIMER" and the timer is set to
"10" (seconds) for all ports.
Summary of Contents for WJGXD900 - MPEG2 DECODER
Page 101: ...101 ...
Page 118: ...118 ...
