4
Preface
By using this software, the following settings of the digital disk recorder WJ-ND300 (A) can be configured on a PC
via a network.
• Network settings
• Registration of cameras, and deletion/edit of the registered cameras
IP addresses of the cameras connected to the WJ-ND300 (A) can be automatically assigned with this software.
When using multiple network disk recorders, it is necessary to configure the above settings independently.
This software works only when the software version of the WJ-ND300 (A) is 3.00 or later.
When failed to configure the above settings with this software, configure them using the setup menu of the WJ-
ND300 (A). To configure the settings of the connected cameras, use the setup software of the cameras.
Refer to the setup instructions (PDF) of the WJ-ND300 (A) or the operating instructions of the camera for further
information.
When the recorder in use is the WJ-ND200, it is possible to configure the network settings of the WJ-ND200 via a
network using this software.
System Configuration
When operating the WJ-ND300 (A)
To configure the settings with this software, connect the PC in which this software is installed to the client PC port of
the WJ-ND300 (A) and the camera to the camera port of the WJ-ND300 (A). When the camera is connected to the
client PC port, it is impossible to detect and configure the camera.
PC in which this software is installed
Client PC port
Camera
Camera
ALARM
ALARM
SUSPEND
OPERATE
ERROR TIMER
REC
1-LINK/ACT-2
HDD1
HDD2
HDD3
HDD4
ESC
SET
PULL
Network Disk Recorder
WJ-ND
WJ-ND300 (A)
Network
Network
Camera port
PUS
H TO
LO
CK/E
JEC
T
PUS
H TO
LO
CK/E
JEC
T
Detection and
configuration are
unavailable
Precaution
Distributing, copying, disassembling, reverse compiling, reverse engineering, and also exporting in violation of export
laws of the software provided with this product, is expressively prohibited.
