Quick settings
27
This section explains how to configure recorder network settings.
1
Click the [Quick] button on the setup menu.
This will display the setting window.
2
Configure the settings for each item.
Refer to “Quick settings 2” table for details about the settings.
3
Under the "Network setup" item, click the [Set] button
When you change the Client PC port IP address, the
"Change IP Address" window will appear. Click [OK] to
complete the process.
Note:
•
Changing the "Client PC port" IP address causes all connected
users to be forcibly logged out. Reconnect with the new IP
address.
•
The recorder reboots after changing the line speed settings and
pressing [Set].
Quick settings 2
♦
Initial default
*1
Refer to "Recorder network settings (page 11)" for information on initial default settings.
Network setup
Item
Settings
Description
Network setup- Camera port/Client PC port
DHCP
Off
♦
/ On
Specifies whether a DHCP server is used.
Select [On] to obtain the IP address, subnet mask, and default
gateway from a DHCP server. Select [Off] to enter these
addresses manually.
IP address
Address input
*1
When [DHCP] is [Off], specify the IP address here.
Subnet mask
Address input
*1
When [DHCP] is [Off], specify the subnet mask here.
Default gateway
Address input
*1
When [DHCP] is [Off], specify the default gateway here.
Line speed
Auto
♦
/ 1000M-Full / 100M-Full /
100M-Half / 10M-Full / 10M-Half
Specifies the data line speed.
Network setup - Maintenance port
IP address
Address input
*1
Specifies the IP address.
Subnet mask
Address input
*1
Specifies the subnet mask.
Important:
•
A different subnet should be set for each port.
•
When DHCP is set to [On] and "SD memory rec." is set, an error may occur in the process of startup of the unit when a request to write onto
the SD memory card is made. This occurs when the response from the DHCP server is slow. Once the address has been obtained from the
DHCP server, the error is resolved.
Summary of Contents for WJND400 - NETWORK DISK RECORDER
Page 73: ...4 ...
