Network
65
Use the following procedure to configure settings for using SNMP (Simple Network Management Protocol). Configure these settings when
connecting to an SNMP manager and check the status of the recorder.
1
Click the [Network] button on the setup menu.
2
On the sub-menu that appears, click [SNMP].
This will display the "SNMP Setup" window.
3
Configure the settings for each item.
Refer to “SNMP settings” table for details about the settings.
4
Click the [Set] button.
SNMP settings
♦
Initial default
*1
You can enter the following single-byte alpha-numeric characters and symbols.
A B C D E F G H I J K L M N O P Q R S T U V W X Y Z a b c d e f g h i j k l m n o p q r s t u v w x y z
0 1 2 3 4 5 6 7
8
9 ! # $ % ` ( ) * + , - . / : ; < = > ? @ [ \ ] ^ _ { | } ~
SNMP
Item
Settings
Description
Community Name
input
(Blank
♦
)
Enter the community name to be monitored.
•
Enter up to 32 single-byte alphanumeric characters and
symbols.
*1
System name
Name input
(Blank
♦
)
Enter a name to be used by the SNMP system to manage the
recorder.
•
You can input up to 255 single-byte alphanumeric characters.
Location
Name input
(Blank
♦
)
Enter the location of the recorder.
•
You can input up to 255 single-byte alphanumeric characters.
Contact
Address input
(Blank
♦
)
Enter contact information (mail address, etc.) for the recorder
administrator.
•
You can input up to 255 single-byte alphanumeric characters.
Summary of Contents for WJND400 - NETWORK DISK RECORDER
Page 73: ...4 ...
