Panasonic WV-NW502S, Installation Manual

13

Before start the installation/connection,
prepare the required devices and cables. 

Before starting the connection, turn the
power of the devices including this product
and the PC off. 

Warning:

Refer installation work to the

dealer. Failure to observe this may
cause fire, electric shock, injury, or
damage to the product. 

The product is designed to be installed
under eaves. 

Do not install this product in locations subject
to direct sunlight. 

Installing place

Contact your dealer for assistance if you are
unsure of an appropriate place in your partic-
ular environment. 

• Make sure that the installation area is

strong enough to hold this product, such
as a concrete ceiling. 

• Install the camera in the foundation area

of the architecture or where sufficient
strength is assured. 

• If a ceiling board such as plaster board

is too weak to support the total weight,
the area shall be sufficiently reinforced. 

Avoid installing in the following locations. 

• Locations where a chemical agent is

used such as a swimming pool

• Locations subject to steam and oil smoke

such as a kitchen, Locations near flam-
mable gas or vapor

• Locations where radiation or x-ray emis-

sions are produced, Locations subject to
strong magnetic field or radio waves

• Locations where corrosive gas is pro-

duced, Locations where it may be dam-
aged by briny air such as seashores

• Locations where the temperature is not

within –30 °C - +50 °C {–22 °F - 122 °F}. 

• Locations subject to vibrations (This

product is not designed for on-vehicle
use.)

• If a ceiling board is too weak to support

the total weight, the area shall be suffi-
ciently reinforced. 

Do not install this product in a humid or
dust-laden environment.

Otherwise, lifetime of the internal parts may
be shortened. 

Be sure to remove this product if it is not
in use. 

Design and engineer the power supply
system to turn on/off the power of the
camera since this product does not have
the power switch. 

About the network connection

When connecting to a network using the net-
work cable of this product, observe the fol-
lowing. 

• When wiring for the network, design and

engineer to not to be affected by thun-
der. 

• It is impossible to install this product in

combination with a pan/tilt head. 

Screw tightening

• The screws and bolts must be tightened

with an appropriate tightening torque
according to the material and strength of
the installation area.

• Do not use an impact driver. Use of an

impact driver may damage the screws or
cause tightening excessively.

• When a screw is tightened, make the

screw at a right angle to the surface. 

• After tightening the screws or bolts, per-

form visual check to ensure tightening is
enough and there is no backlash. 

Precautions for Installation