52
52
53
Configure the settings relating to MPEG-4 images
[JPEG/MPEG-4]
Click the [JPEG/MPEG-4] tab on the "Image/Audio" page. (
☞
Pages 26 and 27: How to display/operate the setup
menu)
The [JPEG/MPEG-4] tab will be displayed when "MPEG-4" is selected for "Video encoding format". (
☞
Page 49)
Configure the settings relating to MPEG-4 image such as "Max bit rate (per client)*", "Image capture size", "Image
quality", etc. in this section. Refer to page 47 and 49 for the settings relating to JPEG images and H.264 images
respectively.
[Video encoding format]
Select "MPEG-4" for the video encoding format.
■
MPEG-4 (1) · MPEG-4 (2)
[MPEG-4 transmission]
Select "On" or "Off" to determine whether or not to
transmit MPEG-4 images.
On:
Transmits MPEG-4 images.
Off:
Does not transmit MPEG-4 images.
Default:
On
Important:
• When "4:3(800x600)"* or "16:9" is selected for
"Aspect ratio", MPEG-4 transmission is unavailable.
*
SW395
SC385
• When "H.264" is selected for "Recording format",
MPEG-4 transmission is unavailable.
Note:
• When "On" is selected for "MPEG-4 transmission"
in "MPEG-4(1)" or "MPEG-4(2)", displaying of
MPEG-4 images or JPEG images on the "Live" page
will be available.
• When "On" is selected for "MPEG-4 transmission"
in "MPEG-4(1)" and "MPEG-4(2)", MPEG-4 images
are viewable using other devices with each setting.
• When "On" is selected for "MPEG-4 transmission"
in "MPEG-4(1)" or "MPEG-4(2)", the transmission
interval of JPEG images may be longer.
[Internet mode (over HTTP)]
Select "On" when transmitting MPEG-4 images via the
Internet. It is possible to transmit MPEG-4 images with-
out changing the broadband router settings configured
for JPEG image transmission.
On:
MPEG-4 images and audio will be transmitted
using the HTTP port. Refer to page 94 for further
information about the HTTP port number settings.
Off:
MPEG-4 images and audio will be transmitted
using the UDP port.
Default:
Off
