Wire through a hole in the ceiling
Step 1
Fix the camera mount bracket (accessory) with four
optional fixing screws (M4 or M6, option).
There should be no obstacles such as wall in a range of
100 mm {3-15/16 inches} away from the center point of
the camera mount bracket.
Step 2
Make a hole in the ceiling to pass the cables through.
Make a hole 25 mm {31/32 inches} in diameter. The cen-
ter point of the hole should be located approx. 75 mm
{2-15/16 inches} away from the center point of the cam-
era mount bracket.
Step 3
Insert the SDHC/SD memory card into the SDHC/SD
memory card slot. Refer to page 26 for how to insert the
SDHC/SD memory card.
Step 4
Attach the safety wire fixed with the camera mount
bracket (accessory) to the camera.
After attaching the safety wire to the camera, confirm that
the ring part at the end of the safety wire is securely
hooked on the safety wire holder.
Step 5
Connect cables to the External I/O terminals, microphone/
line input connector, audio output connector and the
monitor out connector for adjustment. When connecting
these cables, hold the base part of the camera.
• External I/O terminals
Connect external devices.
When connecting an external device, remove 9 mm -
10 mm {11/32 inches - 13/32 inches} of the outer jacket
of the cable and twist the cable core to prevent the short
circuit first.
Shooting direction (FRONT)
Screw
(M4)
83.5 mm
{3-9/32 inches}
Screw
(M6)
100 mm {3-15/16 inches} or more
away from obstacles such as wall
64 mm {2-17/32 inches}
46 mm
{1-13/16 inches}
110 mm
{4-5/16 inches}
FRONT
OPEN
LOCK
75 mm
{2-15/16 inches}
Wiring hole
(ø25 mm {31/32 inches})
FRONT
OPEN
LOCK
Safety wire holder
Safety wire
MONITOR OUT
AUDIO OUT
MIC/LINE IN
EXT I/O
4 3 2 1
12V IN
POWER
INITIAL
SET
ACT
LINK
10BASE-T/
100BASE-TX
External I/O terminals
Base
part
Microphone/line
input connector
Audio output connector
Monitor out
connector for
adjustment
16
Summary of Contents for WV-SC385PJ
Page 39: ......
