Panasonic WV-SF448 Operating Instructions Manual Download

Page: 20 / 228

[AUX] buttons

These buttons will be displayed only when “Terminal 3” of “Alarm” is set to “AUX output” on the setup menu.
(

page 129)

•

[Open] button:

The letters “Open” on the button will turn green and the status of the AUX connector

will be open.

•

[Close] button:

The letters “Close” on the button will turn green and the status of the AUX connector

will be closed.

[Rec. on SD] button

This button will be displayed only when “Manual” is selected for “Save trigger” on the setup menu.
(

page 67)

Click this button to manually record images on the SD memory card. Refer to page 39 for descriptions
of how to manually record images on the SD memory card.

[Log] button

[List] button will become available only when “On” is selected for “Save logs” on the setup menu.
(

page 83) When this button is clicked, the log list will be displayed and images saved on the SD memory

card can be played. Refer to page 45 for further information about the log list and for how to play images
on the SD memory card.

[Multi-screen]

Images from multiple cameras can be displayed on a multi-screen by registering cameras on the setup
menu. (

page 23)

[Zoom] buttons

(when the image type is Quad PTZ or Single PTZ)

An image selected on the “Control Image” can be zoomed.

•

Click this button to adjust the zoom ratio to the “Wide” side.

•

Click this button to set the zoom ratio to x1.0.

•

Click this button to adjust the zoom ratio to the “Tele” side.

[Fisheye Control] button

When the [Fisheye Control] button is clicked, the “Fisheye Control” window will be displayed on a newly
opened window, and operations can be performed. (

page 12)

[Auto mode]

Select an operation from the pull-down menu and click the [Start] button. The selected operation will start.
Click the [Stop] button to stop the operation. The selected operation will stop when the camera (panning/
tilting/zooming) is operated or when an action that is to be taken according to the settings for “Self
return” (

page 103) starts.

•

Auto pan:

Automatically pans.

Even when the camera is operated for zooming, the camera continues panning.
(However, panning will stop when the zoom button (x1) is clicked.)

•

Preset sequence:

Automatically moves to the preset positions (

page 113) orderly (start from the

lowest preset position number).

Note

•

If auto pan is used when the camera is mounted on a wall, depending on the tilt position, it may
appear that the range of auto pan is reduced and the camera is not panning. In this case, adjust
the tilt position up or down.

Control pad/buttons

Left-click on the control pad to adjust the horizontal/vertical position of the camera (panning/tilting).
It is also possible to pan/tilt the camera by dragging the mouse.
Zoom can be adjusted by right-clicking. When an upper/lower area of the control pad is right-clicked, the
displayed image will be zoomed in/out on. Zoom can also be adjusted using the mouse wheel.

[Control Image] pull-down-menu

When the image type is Quad PTZ, select the screen number of the image to control its preset, zoom,
control pad/button settings.

Operating Instructions

1 Monitor images on a PC